We need to distinguish between:
For Linux and BSD systems IPv6 is automatically enabled when a network
interface is detected with a global IPv6 address. This check is done
You can override what this function returns by calling
Netsys.set_ipv6_system. This is needed on other OS where the
automatic check does not work, and of course also when IPv6 needs to
be turned off.
Neturl module can parse URLs containing IPv6 addresses, e.g.
http://[fe80::224:7eff:fedf:59ff]/path. The address must be included
in square brackets, following common Internet standards. These square
brackets remain in place if the host part of the URL is extracted from
the URL with
Neturl.url_host. Note that
cannot process such brackets. Because of this, another function
Neturl.url_addr has been added which returns the IP address
For simple host/port pairs like
localhost:3128 another abstraction
has been added,
Netsockaddr.socksymbol_of_string one can parse such pairs, and IPv6
addresses are supported. Again, these addresses need to be enclosed in
Note that it is possible to map IPv4 addresses into the IPv6 address space.
Such addresses have the form
XXXX:XXXX is the
IPv4 address. Such addresses are normally written
that the IPv4 address is denoted as the well-known dotted quadruple.
You get such addresses when a server socket is bound to
:: and receives
IPv4 traffic. The consequence is that the same IPv4 address exists in
two forms, namely as native IPv4 address and as IPv4-mapped-to-IPv6 address.
Netsys.norm_inet_addr to normalize an address and
Netsys.ipv6_inet_addr to enforce the mapped form.
The protocol interpreters for HTTP, FTP, and SOCKS have been carefully reviewed, and the necessary changes have been done.
The implementations for SMTP, POP, and the web connectors do not contain IP addresses (or are uncritical).
Regarding SunRPC, the Portmapper protocol does not support IPv6. To cope with that, some support for RPCBIND, the successor of Portmapper, has been added. First the required RPCBIND requests are tried, and if it is detected that RPCBIND is unavailable, the old Portmapper requests are done instead. Note that in the latter case IPv6 is not possible.
The central name service module is
Uq_resolver. The name resolver
is now pluggable, and there are two versions:
gethostbyname, and is typically IPv4-only (but this is OS-dependent).
getaddrinfo, and supports both IPv4 and IPv6. One can set which address types are enabled.
getaddrinfomay not be available on all platforms, but it always available for platforms supporting IPv6.
true, the standard resolver is automatically changed to
Uq_resolver.gai_resolverin order to allow IPv6 name lookups.