class type rec_out_channel =Recommended output class type for library interoperability.
This class type is defined in "Basic I/O class types" as collaborative effort of several library creators.
intargument is the position of the substring, and the second
intargument is the length of the substring where the data can be found. The method returns the number of octets actually written.
The implementation may choose to collect written octets in a buffer before they actually delivered to the underlying resource.
When the channel is non-blocking, and there are currently no bytes to write, the number 0 will be returned. This has been changed in ocamlnet-0.97! In previous releases this behaviour was undefined.
When the channel is closed, the exception
Closed_channel will be
raised if an ocamlnet implementation is used. For implementations
of other libraries there is no standard for this case.
When the channel is already closed, this is a no-op.
close_out method has actually two tasks: First, it writes out
all remaining data (like
flush), and second, it releases OS
resources (e.g. closes file descriptors). There is the question
what has to happen when the write part fails - is the resource released
anyway or not?
We choose here a pragmatic approach under the assumption that
an OS error at close time is usually unrecoverable, and it is
more important to release the OS resource. Also, we
assume that the user is wise enough to call
flush first if
it is essential to know write errors at close time. Under these
flushmethod fully reports any errors when writing out the remaining data.
flushraises an error exception, it should discard any data in the buffer. This is not obligatory, however, but considered good practice, and is subject to discussion.
close_outmethod usually does not report errors by raising exceptions, but only by logging them via
Netlog. The OS resource is released in any case. As before, this behavior is not obligatory, but considered as good practice, and subject to discussion.
try ch # flush(); ch # close_out(); with error -> ch # close_out(); raise error
There are some cases where data can be first written when it is
known that the channel is closed. These data would not be written
by a preceding
flush. In such cases:
write_eof, that marks the data as logically being complete, so a following
flushcan do the complete shutdown cycle of the channel.
close_outreleases the descriptor: the first
close_outwill report the error condition as exception, but discard all data in the channel. The second
close_outfinally releases the OS resource.