Plasma GitLab Archive
Projects Blog Knowledge

Module Netpop

module Netpop: sig .. end
This is an interface for the Post Office Protocol - Version 3 (POP3) as specifed by RFC 1939. The protocol is intended to permit a workstation to dynamically access a maildrop on a server host in a useful fashion.

type state = [ `Authorization | `Transaction | `Update ] 
exception Protocol_error
exception Authentication_error
exception Err_status of string
exception Bad_state
val tcp_port : int
Default TCP port for POP version 3
class client : Netchannels.in_obj_channel -> Netchannels.out_obj_channel -> object .. end
The class client implements the POP3 protocol.
class connect : ?proxy:#Uq_engines.client_endpoint_connector -> Uq_engines.connect_address -> float -> client
connect addr timeout: Connects with the server at addr, and configure that I/O operations time out after timeout seconds of waiting.
val authenticate : ?tls_config:Netsys_crypto_types.tls_config ->
?tls_required:bool ->
?tls_peer:string ->
?sasl_mechs:Netsys_sasl.sasl_mechanism list ->
?sasl_params:(string * string * bool) list ->
?user:string ->
?authz:string -> ?creds:Netsys_sasl.credentials -> client -> unit
Authenticates the session:

  • requests capabilitlies
  • if the server supports TLS, and tls_config is set, the TLS session is started, and the capabilities are refreshed.
  • if SASL support is announced by the server, one of the sasl_mechs is taken and used for authentication. If sasl_mechs is empty, this authentication step is skipped.
Options:

  • tls_config: if set, TLS is tried on the connection
  • tls_required: if set, it is even required that TLS is supported. If not, a Netsys_types.TLS_error exception is raised.
  • tls_peer: the host name of the server (only needed for TLS, and only needed if the TLS configuration authenticates the server, or if the SNI extension is active)
  • sasl_mechs: available SASL mechanisms (in order of preference). If you pass mechanisms, you'll normally also need to pass user and creds.
  • sasl_params: parameters for SASL. A "digest-uri" parameter is always generated, and need not to be set
  • user: the user name to authenticate as
  • authz: the identity to act as (authorization name)
  • creds: credentials
You can get a simple TLS configuration with:

let tls_config =
  Netsys_tls.create_x509_config
    ~system_trust:true
    ~peer_auth:`Required
    (Netsys_crypto.current_tls())
     

SASL example:

Netpop.authenticate
  ~sasl_mechs:[ (module Netmech_scram_sasl.SCRAM_SHA1);
                (module Netmech_digest_sasl.DIGEST_MD5);
              ]
  ~user:"tom"
  ~creds:[ "password", "sEcReT", [] ]
  client


Debugging


module Debug: sig .. end
This web site is published by Informatikbüro Gerd Stolpmann
Powered by Caml